Comic Discussion > QUESTIONABLE CONTENT

Pintsize and Winslow Toys

<< < (8/9) > >>

Carl-E:
Deadlywonkey, you're seriously over-engineering this...

How about a resin or plastic figure with limbs and head on same-sized dowels that can be interchanged in the chassis' holes, with a pivot joint (maybe ball and socket) on each for posing (or not), with a traditional doll stand. 

Remember, it's a toy.  The engineering principle KISS (Keep It Simple, Stupid) applies here. 

Interestingly, Pintsize (and Winslow, maybe Momo) are the least-changing characters in the strip, and so the most likely for figures.  Anyone else won't resemble themselves after a few hundred strips or so! 

Skewbrow:
OMFG! I should have known better than tempt an engineer. All I wanted was magnetically de-/attachable limbs and head :-). Probably wouldn't have hurt to be more specific  :roll:

pwhodges:
Make it a plushy anyway, and use velcro attachments.

Deadlywonky:

--- Quote from: Carl-E on 31 Mar 2011, 04:50 ---Deadlywonky, you're seriously over-engineering this...

--- End quote ---

But it would be able to walk! also FIFY

A resin model would be fine, but you could use magnets to be inkeeping with the 'real' Pintsize.

cesariojpn:
Howabout a Momo doll with the.........

Navigation

[0] Message Index

[#] Next page

[*] Previous page