Fun Stuff > CHATTER
Tattoos and other body mods
ackblom12:
Here. Lots of sizes, very light and pretty cheap. Also, you're 1" right? If so, I'm going to guess you would be able to start back up with 1/2". Don't take that for gospel mind you, everyone's different, but it's a pretty likely bet.
Carl-E:
Neko, is there anything you can coat the contact surfaces of the stone with?
Clear nail polish? Polyurethane? Turtle wax?
ackblom12:
Unless it was a iron ore stone or something I doubt it was the stone itself that caused the issue, though it could have been a scratched surface or something. Was it sharp flares, too big a flare or something?
nekowafer:
They ended up being pretty low quality, but they seemed fine - cracked and chipped on the surfaces but the wearable felt smooth enough. So I'm honestly not sure what happened.
nekowafer:
--- Quote from: ackblom12 on 03 Jul 2013, 20:40 ---Here. Lots of sizes, very light and pretty cheap. Also, you're 1" right? If so, I'm going to guess you would be able to start back up with 1/2". Don't take that for gospel mind you, everyone's different, but it's a pretty likely bet.
--- End quote ---
You are correct, I was at an inch. But the left one is SO pissed off... there was blood. It's already way down. The right one may stop at 1/2", but I'm guessing the left will be much smaller. It sucks, I have fancy new jewelry coming in that I won't be able to wear for a very long time. :(
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version