Comic Discussion > QUESTIONABLE CONTENT

QC Captions vol. 343

<< < (4/4)

Mr_Rose:

--- Quote from: Dave H on 25 Oct 2017, 17:10 ---
--- Quote from: Storel on 25 Oct 2017, 16:17 ---Not knowing anything about it myself, what exactly would you do with a rotational viscometer in a robot repair shop?
--- End quote ---

Custom blended hydraulic fluid for the discerning android-about-town?


--- End quote ---
Or, indeed, measuring the fluid they just drained off to make sure it’s within spec.

Thrudd:

--- Quote from: Mr_Rose on 26 Oct 2017, 04:24 ---
--- Quote from: Dave H on 25 Oct 2017, 17:10 ---
--- Quote from: Storel on 25 Oct 2017, 16:17 ---Not knowing anything about it myself, what exactly would you do with a rotational viscometer in a robot repair shop?
--- End quote ---
Custom blended hydraulic fluid for the discerning android-about-town?

--- End quote ---
Or, indeed, measuring the fluid they just drained off to make sure it’s within spec.

--- End quote ---
My experience has been with the QC testing of polymers. Either thermo-set or epoxy. You need a specific level of viscosity for molding or potting parts but not too thin else it will leak like water and be weak or too thick and leave voids.
Testing thinner fluids like lubricants or blood is usually relegated to a custom glass tube type system, a stopwatch and a look-up table. (click to show/hide)

Is it cold in here?:
I remain after all these years in awe of the kind of expertise this forum can toss up on apparently almost anything.

Navigation

[0] Message Index

[*] Previous page